Evo-Fort4 stand alone (evo-all) with THAR4
I have installed this unit into my 2016 Ford Escape. The car starts, then the door ajar alert comes up on my display, the car honks 6 times (three short bursts of two honks) and shuts off.
Lock and unlock wires were tapped without issue, the driver door pins were cut and spliced to the evo per directions and in appropriate polar direction.
The driver door ajar sensor functions appropriately when started by key ( as long as evo 20 pin connector is connected to module)
I have already flashed the module to the current firmware and updated for my vehicle. Any advice? Is there maybe a more detailed walk through for the options when using flash link updated? At a loss here.
Also, the fortin 2 way long range RF kit provided green light confirmation on programming but will not start lock or unlock my car.
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
